Building Those Old Kits ... Not Enough Information?

Building Those Old Kits – Not Enough Information?

Building Those Old Kits – Not Enough Information? On lots of the plans sheets that came with those old (stick-and-tissue, printwood, rubber powered and maybe sort-of-flyable) model airplane kits pretty much all you got was plans. Instructions that actually helped you figure out what came next were not always part of the deal. For a […]

Continue reading

Building the Stinson SR-9 (23)

Now we get to one of those places where “doing scale” starts to get a higher weird factor.  I can guarantee you that the many hours you may spend doing what I’ll describe this time will never make your model airplane fly better.  What a well done stitch-and-tape job will do is guarantee that your […]

Continue reading

Building the Stinson SR-9 (22)

Before we get started on this month’s installment of our Building the Stinson story, I want to invite any and all of you who are reading my rcmodel.com blogs to participate in deciding where they will be going next. I have been working on the big Top Flite/Great Planes Stinson SR-9 for over two years, and as […]

Continue reading

Product Review…Venom Group/Atomik SKYANGEL Mini-warbirds SeaFury

  What’s Bob doing with those ARF Foamies?  If you have been following rcmodel.com for any time at all, you’re probably asking yourself “What’s Bob Benjamin doing with foam ARF models?” This guy is the original building them from balsa is better…forever… hard case guys. Well, to put it most simply, I’m doing it because […]

Continue reading

We Visit Venom Group (Those LiPo Battery Guys)

  This is no small operation! What appears to be most of the VPW crew turned out for a group photo with their building in the background.   Over the years that I have been involved with the world of aeromodeling there have been increasingly frequent occasions when I was given the opportunity to represent […]

Continue reading

Building the Stinson SR-9 (21)

Yes!!! It’s finally time to put some covering on the Stinson SR-9. When we’re dealing with a traditional “built-up” structure like this one (as opposed to a box structure made of sheet balsa or perhaps molded composite) you might say that all the work I’ve done so far has been leading up to this moment. […]

Continue reading

Building the Stinson SR-9 (20)

The Stinson SR-9 project is getting very close to the  time for me to begin covering and finishing, but there are a few installation details to be completed before I will actually be ready for “closing up” the structure. In the case of this airplane that means putting on a fabric covering. For me this […]

Continue reading

Building the Stinson SR-9 (19)

The Stinson SR-9, like most high-wing single-engine monoplanes of the 1930’s, relies on external strut bracing to stay together in flight. The SR-9 uses a single, large strut under each wing rather than the multi-strut assemblies like the ones you’re familiar with on Pipers, Aeroncas, Taylorcrafts, and so on, and it uses a pair of […]

Continue reading

Building the Stinson SR-9 (18)

After working on the windshield, with all those curves and bulges, you couldn’t help seeing what’s coming next. The main landing gear assembly on all the big gull-wing Stinsons is almost baroque with its imposing presence and all those complex interacting fairings. You’ve gotta’ love compound curved surfaces to love this airplane…but…that’s why you’re building  one of […]

Continue reading

Building the Stinson SR-9 (17)

On a lot of models the windshield is actually a blown “bubble” canopy that gets stuck to the top of the fuselage, or a piece of clear plastic that’s molded to fit on the nose ahead of the wing. In either case a couple of screws or some canopy glue takes care of the job […]

Continue reading